Studiologic Numa Organ 2 Manual de usuario Pagina 18

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 50
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 17
NUMA ORGAN 2 by Studiologic®
18
Operation
To create your favourite sound, you can move through all the para-
meters on the control panel. Once you nd the right combination,
you can store the obtained sound in one of the 11 keys of the re-
versed octave, by following the procedure below:
- Press the Preset/[Sound] button on the panel, to switch it on (LED
status: ON);
- Keep pressing for a few seconds the Preset key in the reversed
octave, where you want to store the current sound and panel setup;
- Wait until the related LED ashes, conrming that the sound is sto-
red in the selected Preset.
Note: the B key is a Panel control and the related location is not storable
as preset, but it keeps the Sound (Model) B as a default sound and it is set
to the actual conguration of all controls (drawbars and all other panel’s
switches and potentiometers).
Note: the instrument stores all eect controls and settings in any Preset.
The Numa Organ 2 can reproduce sounds of dierent vintage or-
gans. The technology of the sound engine can emulate dierent
sound models as explained in the Introduction at pages 7,8.
To select the dierent sound models, follow the procedure below:
- Keep pressing the Preset/[Sound] button until it ashes (LED sta-
tus: FLASH);
- Select the Sound Model from the list below:
Sound 1 (C): Classic Organ Principal (Diapason Pipe Partials)
Sound 2 (C#): empty
Sound 3 (D): Electronic Organ Model V (Mellow Triangle)
Sound 4 (D#): empty
Sound 5 (E): Electronic Organ Model D (Sweet Square)
Sound 6 (F): Electronic Organ Model F (Smooth Sawtooth)
Sound 7 (F#): empty
Sound 8 (G): Tone wheel Organ Model C (C3-G)
Sound 9 (G#): empty
Sound 10 (A): Tone wheel Organ Model A (A100-A122)
Sound 11 (A#): empty
Sound 12 (B): Tone wheel Organ Model B (B3)
Note: this list could be updated with future sound implementations.l
- To escape the Sound Selection function press again the Preset/
[Sound] button (LED status: ON/OFF).
Note: during the Sound Selection procedure it’s always possible to use the
Drawbars and any other eect and/or control; if you want to store the se-
lected Sound together with the current panel setup, follow the Preset Store
Procedure above.
Preset Store
Sound Selection
Vista de pagina 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 49 50

Comentarios a estos manuales

Sin comentarios